Messages

21

General Mach Discussion / Re: re:CNC Lathe program

« on: August 16, 2012, 11:58:01 AM »

Thanks guys i am trying to learn where all the buttons and switches are that make it all run.

Dennis

22

General Mach Discussion / Re: re:CNC Lathe program

« on: August 15, 2012, 12:47:55 PM »

I  have version 10 i have not purchased it yet as i wanted to fix the problems i was having with the example code in Mach.

Dennis

23

General Mach Discussion / Re: re:CNC Lathe program

« on: August 14, 2012, 05:19:56 PM »

Rich
Dolphin kept sending me a different post every time i contacted them it was hi Dennis try this post see if it works so i don't know what they sent but i am with you on the kiss method i will use the #73 and #96 see what happens thanks again.

Dennis

24

General Mach Discussion / Re: re:CNC Lathe program

« on: August 13, 2012, 01:06:35 PM »

Hood
 I checked it and then tried the code the cutter would clip the back side of the balls but when i unchecked it the cutter ran along the back side with out clipping them.

Dennis

25

General Mach Discussion / Re: re:CNC Lathe program

« on: August 12, 2012, 02:10:46 PM »

Hood
I work with the settings in Mach and got it to display the proper code file Balls for Dennis What i changed was Diam unchecked reverse Arch, Distance changed to absolute and IJ to absolute and the code displayed was correct so i think i have the problem fixed at least it seams so right now next i will go back to Dolphin and see if i can draw a part and code it to run on Mach.

Many thanks for your and Rich help
Dennis

26

General Mach Discussion / Re: re:CNC Lathe program

« on: August 12, 2012, 01:03:11 PM »

Hood
In one of my earlier post i stated that I had made the changes to Mach going to Dia & absolute also the code had a G90 at the start but the screen showed the same crop circles and the cutter followed the display so for sure something is wrong just don't know what?

Thanks
Dennis 

27

General Mach Discussion / Re: re:CNC Lathe program

« on: August 11, 2012, 05:24:05 PM »

Hood
This is the file i found MAch loading displayed in the lower right hand corner of the screen.

Thanks
Dennis

28

General Mach Discussion / Re: re:CNC Lathe program

« on: August 11, 2012, 01:34:09 PM »

Hood / Rich
Hood i look for the file Bu ti don't understand the reason to look for a mill screen set XML as i am using a modified mill screen 1024 LSET.
Rich I will load the modified XML you posted and see what gives thank you both for the help.

Dennis

29

General Mach Discussion / Re: re:CNC Lathe program

« on: August 09, 2012, 07:08:42 PM »

Hood
Finlay the system took the file i had made several attempts to upload it but the system would not accept the file even changing the name.

Thanks
Dennis

30

General Mach Discussion / Re: re:CNC Lathe program

« on: August 09, 2012, 07:07:22 PM »

Hood
How about this one .

Dennis