Messages

121

Third party software and hardware support forums. / master cam X4

« on: March 16, 2011, 01:29:52 PM »

hi guy's
question under machine type what type of machine should I select to run mach-3 ? many thanks for any help.

Dennis

122

LazyTurn / Re: LazyTurn

« on: March 02, 2011, 06:49:27 PM »

Hi ART
First off again thanks for taking this far as to the G-code i like it because if there is a glitch i can track it down and remove that line of code such as i do in the mill side.
Well i will check back in looking for the last version of LT.

Dennis

123

General Mach Discussion / Re: XML restore

« on: March 02, 2011, 06:46:16 PM »

Hi Hood
Problem is all the code and XML are on a stand alone system no internet connection i have to copy it all to a drive and then to the internet computer.

Dennis

124

General Mach Discussion / Re: XML restore

« on: March 02, 2011, 03:22:11 PM »

Thanks Hood
One more question i have is in my G-code i have the feed at 400 MM but when the G-code is run on the machine the feed rate is 290 MM not 400 i have to over ride the feed up to 560 before i get the feed rate i wish to have the machine operate at.

125

General Mach Discussion / XML restore

« on: March 02, 2011, 12:55:45 PM »

Hi Guy's
I have updated my version of Mach and it lost the setting's i have a back up and there are saved back UP's of Mach in the back up file folder question is how do i restore the XML a simple copy and paste dose not work any and all help is always greatly appreciated.

Dennis

126

LazyTurn / Re: LazyTurn

« on: March 02, 2011, 12:51:33 PM »

Hi Art & all
Thanks for your reply and all the work that you have put into LT i guess from what i am reading LT has gone as far as it's going to well i guess that's the way the cookie crumbles.

Dennis

127

LazyTurn / Re: LazyTurn

« on: February 28, 2011, 06:16:29 PM »

hi Guy's
I had posted a question regarding is a finished version of LT was done but now i don't even see my post have I been banished ?

Dennis

128

LazyTurn / Re: No post of the G-code

« on: February 28, 2011, 12:27:15 PM »

Hi Guy's
Just checking in, is there a finished version of LT yet ?

Rg's
Dennis

129

LazyTurn / Re: LazyTurn

« on: December 14, 2010, 12:01:19 PM »

Hi Guy's checking in
is there been a finished version of LT ?

Dennis

130

General Mach Discussion / Re: Mach did again!

« on: October 08, 2010, 12:38:11 PM »

Ergerber
 Good to hear you have the problem solved i use a tool change but not as many as you have noted so far anyway and found no problem to date in the mill application lathe is another issue.

Dennis