Messages

271

General Mach Discussion / Re: Milling machine wirth servos

« on: March 11, 2008, 11:29:51 AM »

Hi Tp
 Sorry for the delay in getting back to your post the old drives are gone sold them along with all the other stuff i removed from the machine.

Dennis

272

General Mach Discussion / Re: Milling machine wirth servos

« on: March 08, 2008, 12:03:39 PM »

Hi Ben
 Since starting out on this project and finding out that the pixes have been discontinued i installed a set of Gecko servo drives they are up and running now on the machine i still have some other thing's to finish up it now has it's own computer in the electronics bay and a new monitor key board ETC but thanks for the help.

Dennis

273

LazyTurn / Re: LazyTurn

« on: March 05, 2008, 02:59:16 PM »

RC
Great then because i purcahsed a LIC for LC i have the pro version.

Dennis

274

LazyTurn / Re: LazyTurn

« on: March 05, 2008, 10:27:01 AM »

I was just looking at the software purchase page and just remembered i purchased a LC lic will it cover the pro version?

Dennis

275

LazyTurn / Re: LazyTurn

« on: March 05, 2008, 10:20:02 AM »

RC
 Thanks for pointing that out to me i have not gone through all the post on this subject OK i didn't know there are 2 different versions of LC i thought what i had was the only version so what do you get with the Pro version that the standard version won't do?

Dennis

276

LazyTurn / Re: LazyTurn

« on: March 04, 2008, 11:38:20 AM »

Hi Art
 Thanks for getting to lazy cam turn as with the others i have been waiting for it question will there be a separate lazy cam download will my LIC work with it ?

Dennis

277

LazyTurn / Re: LazyTurn

« on: February 21, 2008, 11:09:13 AM »

Hi Art
I have just checked in and found you are working on turn great i have been waiting for it  looks great don't stop now your on a roll.

Rg's
Dennis

278

General Mach Discussion / Re: re: milling machine with servos

« on: January 14, 2008, 04:29:18 PM »

Hi Guys
I thought i had the first fight resloved when it bit me in the rear mother board went down so i replaced it with a newer board and of course you have to change the processor and memory right anyway after doing this Mach will not mount the printer port with any control to the servos i have tried a printer on the port LPT port and it works fine but still no mach control don't what the problem is i had this problem when first did the installation but simply connecting a printer on the computer seamed to solve the problem but not this time as always any ideas and or help is greatly appreciated.

Dennis

279

General Mach Discussion / Re: re: milling machine with servos

« on: January 10, 2008, 03:42:35 PM »

Chip
Don't which will occur first me going bonkers or the machine working will just have to wait and see : )

Dennis

280

General Mach Discussion / Re: re: milling machine with servos

« on: January 10, 2008, 03:40:34 PM »

Chip
Don't know which will happen first me going bonkers and the machine working just have to wait see which goes first.

Dennis