333
« on: October 12, 2007, 04:22:15 PM »
Hi guy's
Need a little help i have a Lagunmatic milling machine with a dyna path control something is down in the controller and dyna path was less then helpful so now i want to remove the controller and run it with my MAch 3, question is can i use the same drivers that are in the machine as they seam to be ok also can i use an interface board such as CNC4PC to run the drives.
Next question how do I actuate the direction on the drives to test the servos out when i installed geckos on my lathe i did actuate the drives moving the steppers just can't remember which wire and i don't want to fry anything if i can help it.
Thanks
Dennis