Hello Guest it is March 29, 2024, 03:55:56 AM

Author Topic: Newbie to cnc building in need of some help please  (Read 7376 times)

0 Members and 1 Guest are viewing this topic.

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Newbie to cnc building in need of some help please
« Reply #30 on: January 20, 2019, 10:34:25 AM »
just to confirm:

-Settings -> Port's&Pin's -> Port Setup and axis selection -> Port 1 is enabled
-Settings -> Port's&Pin's -> Port Setup and axis selection -> Port 1 adress is set correctly
-Settings -> Port's&Pin's -> Motor Outputs -> axis is enabled
-Settings -> Port's&Pin's -> Motor Outputs -> Step Pin , Dir Pin and port are correct
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Newbie to cnc building in need of some help please
« Reply #31 on: January 20, 2019, 10:43:59 AM »
port 1 is enabled. port address is in question. axis is enabled. I'm pretty sure i have pins and ports correct. x=2,3 y=4,5 z=6,7
if i go into my control panel I'm not sure what I'm looking for. 
Re: Newbie to cnc building in need of some help please
« Reply #32 on: January 20, 2019, 10:46:06 AM »
when i click on devices in my control panel all it shows is a microsoft xps document writer and I'm not sure why that is

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Newbie to cnc building in need of some help please
« Reply #33 on: January 20, 2019, 10:50:24 AM »
sorry have only a german version
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Newbie to cnc building in need of some help please
« Reply #34 on: January 20, 2019, 10:57:43 AM »
lol I wish I knew what that said. However the only devices shown connected in my control panel are wifi adapter , keyboard,moniter, pc and mouse.
I deleted the document writer because there is none.

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Newbie to cnc building in need of some help please
« Reply #35 on: January 20, 2019, 11:02:24 AM »
but you said, you run drivertest succesfuly?
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Newbie to cnc building in need of some help please
« Reply #36 on: January 20, 2019, 11:03:15 AM »
that is correct
Re: Newbie to cnc building in need of some help please
« Reply #37 on: January 20, 2019, 11:04:16 AM »
just ran it again and it says system excellent

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Newbie to cnc building in need of some help please
« Reply #38 on: January 20, 2019, 11:06:10 AM »
can't run drivertest here (64Bit), is there any port adresss shown?
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Newbie to cnc building in need of some help please
« Reply #39 on: January 20, 2019, 11:07:40 AM »
no port shown