While setting up this plugin, I had a problem getting the motor to even run. I played with it all day, only to find out my spindle motor burnt up. Now I don't know if it was caused by the plugin or if it was on it's way out beforehand. The spindle ran fine before the plugin was installed. I installed the latest version, as well as the C++ file and driver for the usb rs485 adapter. After the plugin install, It recognized the settings from the VFD and showed up after the install. It took me a while before I realized I needed to set a speed in the box first before I tried to turn on the motor. Once I did that, it ran, but very erratic. After a few tries to get it to run faster, it just died.
Long story short, after taking apart the spindle motor, with plans to rewind it, I found out that the Chinese 1.5kw water cooled motor is not a four pole motor. The VFD comes preprogrammed for four poles. The motor I have is actually a two pole motor. Now I don't know if that makes any difference, but I thought I would mention it, so others can check their VFD for the right set up. The VFD comes preset for four poles and should only make the motor run half speed. Set for two poles will make it run twice as fast.
Right now, I have my motor all ready for the rewind. I just got my wire yesterday and will start turning soon. Just for those wondering, my motor is over three years old, but only has 10 hours or less on it.
Don