Does anyone have a CNC milling machine combo made by MIB
I HAVE A 4 AXIS MILLING MACHINE with JY5300 machine controller and JY800 power supply speed controller
Spindle motor is 800w and 24000 max rpm water cooled
I had a A>AXIS CARD BURN OUT AND Z> AXIS CARD BURN OUT.
ALL STEPPER MOTORS WORK ON ALL AXIS BY USING THE Y > AXIS CARD TO TEST WITH
using the hand held no PC mode
I'm trying to get the spindle motor to run using MACH3 software loading G-code roadrunner.
I'm total stuck can not get the emergency
reset to stop flashing.
i setup the config part.
i have the MACH3 MANUAL INFO for set up still cannot run the code
HELP PLEASE