Hello Guest it is March 29, 2024, 01:27:16 AM

Author Topic: Newbie to cnc building in need of some help please  (Read 7373 times)

0 Members and 1 Guest are viewing this topic.

Re: Newbie to cnc building in need of some help please
« Reply #20 on: January 20, 2019, 09:59:03 AM »
let me switch my a+ a- b+ b- to match what you sent and see if that does anything. I the link you shared enable as not connected.

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Newbie to cnc building in need of some help please
« Reply #21 on: January 20, 2019, 10:03:35 AM »
see attached
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Newbie to cnc building in need of some help please
« Reply #22 on: January 20, 2019, 10:07:14 AM »
YAY! Little victories. By switching my A's and B's  I can no longer turn ball screws by hand. Still no movement of axis's though.  Enable+ huh? Let me run some quick jumpers.
Re: Newbie to cnc building in need of some help please
« Reply #23 on: January 20, 2019, 10:19:52 AM »
OK so, I ran jumpers from my +5 volt to the Enable + on each drive. I have a powerful hold on my ball screws but still no movement of any axis.

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Newbie to cnc building in need of some help please
« Reply #24 on: January 20, 2019, 10:23:26 AM »
due searching for a Manual for your breakout bord, there seam to be different Versions.

do you have this Version, with the jumper's,
and are both jumper's set ?
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Newbie to cnc building in need of some help please
« Reply #25 on: January 20, 2019, 10:26:08 AM »
btw are your axis dro's changing if you try to jog?
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Newbie to cnc building in need of some help please
« Reply #26 on: January 20, 2019, 10:27:03 AM »
Yes that is the board I have and both jumpers are jumped.
Re: Newbie to cnc building in need of some help please
« Reply #27 on: January 20, 2019, 10:29:00 AM »
yes the DRO's are showing movement in + and - directions

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Newbie to cnc building in need of some help please
« Reply #28 on: January 20, 2019, 10:29:45 AM »
i assume you are using the Standard 1024 sceenset.

is the reset button permanent green or flashing ?
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Newbie to cnc building in need of some help please
« Reply #29 on: January 20, 2019, 10:31:48 AM »
permanent green if I disable the ESTOP. Constant flashing when I set ESTOP port to =1