Sorry but I did, just making sure I heard you right.
Thank you

hood, stirling, tweakie,
I decided to do my hard drive over with a fresh operating system,
also upgraded my CPU.
I will start over and see where that gets me.
Thank you for trying to help.

I think that a fresh, clean, install may just solve the problem (I sincerely hope so).

I look forward to hearing of your progress.

Tweakie.

OK
The battle goes on
64 bit CPU installed
Windows 7 ultimate 64 bit system
LPT1 0X378
Configured Mach3 all over reboot also.
Machine on, loaded Mach3, put the roadrunner code in.
Reset button not flashing
Hit the CYCLE start watched the lines travel in the picture. 
along the road runner. green
Watched the code line move 1 at a time
when it got to line 933 I stopped it.
My machine never moved.
OK
Where is the beer, wine, shine, grass, pills in any order
time to find the star gate entrance and warp

My machine does work fine can switch with a button from hand held
all axis work, to PC no problem.
What next

Mach will not work on a 64bit OS if you are using the parallel port.
Hood

OK
Gotcha
I will go Back 4 steps, at it again
Thank you

OK
Is anyone using a USB to convert from a LPT
Cable adapter FROM LPT to USB

Wont work. Only way you can get USB to work with Mach is use an external motion controller, if doing that then I would suggest you use ethernet instead as its more robust than USB.
And external controllers work with 64bit OS's

Hood

Yes
I have an external motor controller but the main machine is Parallel port.
I will go back to XP and start again.