Block.Format("G%.d X%.4f Y%.4f Z%.4f R%.4f F%.2f",Cycle,ent->startx,ent->starty,Depth,RapidHeight,FeedCut);
feedcut i ask for milling when we use g81 feed cut will be plunger rate
in lazycam
in layer control the set up i made was
feedrate 3000
plunger was 1000
---------N11 G1 Z0.0000 F1000.00
---------N20 G81 X203.8787 Y7.4656 Z0.0000 R12.0000 F3000.00
the reason i ask this i cut plastic using the same router 1/8 bit
the feed to cut the part is good at 3000
but when the z axe go trow the plastif it as to be 1000 to make nice job
in the dxf file we will have is lot of drill hole and line curve etch.
tell me if it could be done it will be very nice to have done