Looks like your board Needs pin14 as enable, have you configured this ?
I'm not sure what you mean. I have an enable ire running from the board #14 to all the drivers. Is there something in Mach3 that needs to be configured that way?
From your earlier picture you have the +24V and GND connected to the wrong side of the breakout board
Tweakie.
I'm not sure where you see that. I triple checked and the 24v supply is correct.
and you have common anode wiring, Setup for Motor Outputs should be dir low aktive and step low active enabled.
just by reading the Manual.
This is another spot where things get weird.
When I test the X motor with the boxes checked, the motor works but is choppy at lower speed.
When I test the motor with the boxes unchecked (red X) the motor runs smoothly.
Checking the boxes or not checking them has zero effect on the Y, Z, and A axis.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Today I got the proper USB connection to the breakout board. Nothing changed. The X still works and the others do not.
FWIW, Best Buy wanted $25 for a straight USB cable. If they wonder why people shop at Amazon, that's why.