Hi there,
I have a laser machine that I've made it myself . I use match3 for controlling my CNC laser machine and I don' have any problem for cutting, but the only problem I've got is that I cannot engrave with high speed. for example if i wanted to engrave one photo, it would take hours to complete! I had been searching and watching some videos on YouTube to understand how to engrave with high speed and noticed some videos that were engraving with really high speed by using the same Match 3 software. I installed the plugin impact/laser Engraving v1.2b on match 3 and when I run this plugin and give the photo for engraving, the machine starts to move by x axial and y axial. My problem is that the signal that should be sent to laser co2 for on and off ,from which pin or axial is getting out?
I control my laser with PWM spindle signal.
Thanks in advance for your reply
Regards,
Javad