Hello Guest it is March 28, 2024, 09:13:21 AM

Author Topic: Impact engraving plugin  (Read 358269 times)

0 Members and 1 Guest are viewing this topic.

Re: Impact engraving plugin
« Reply #190 on: June 29, 2012, 07:56:43 AM »
Tweakie. I have another question:
obtained as shades of gray?
plug-in changes the frequency of the output pulses? or shades can not be obtained from this plugin?
Thank you so much!

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: Impact engraving plugin
« Reply #191 on: June 29, 2012, 08:30:33 AM »
Hi Josaami,

Yes, you are quite correct, my mistake - in my earlier post I should have said the maximum frequency (set by feed rate).

Tweakie.
PEACE
Re: Impact engraving plugin
« Reply #192 on: June 29, 2012, 10:55:58 AM »
Hi Tweakie,
I did not mean the maximum frequency.
I wonder whether you can engrave shades of gray. and how mach will be indicated on the shade? ie it changes the frequency of the output signal (from the minimum frequency of feed rate to the maximum frequency of feed rate), or even like that?
Thank you for your answers! They are very helpful!

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: Impact engraving plugin
« Reply #193 on: June 29, 2012, 12:55:14 PM »
Hi Josammi,

I think I understand but please excuse me if I have misunderstood your question.

It is the ‘density of pulses’ (pulse repetition frequency) calculated from many factors including;  pixel value, axis speed, axis steps per pixel and the Mach3 kernel speed which produces the shades of grey in the final image.

Tweakie.
PEACE
Re: Impact engraving plugin
« Reply #194 on: June 29, 2012, 02:25:55 PM »
Hi Tweakie.
Thank you very much!
Now I understand everything!

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: Impact engraving plugin
« Reply #195 on: June 30, 2012, 01:21:55 AM »
Quote
Now I understand everything!

Hi Josaami,

Once you start using the plugin and closely observing the results I think it will all become a lot clearer.

Tweakie.
PEACE
Re: Impact engraving plugin
« Reply #196 on: June 30, 2012, 08:30:20 AM »
Hi Tweakie.
Thank you.
I will try.
Program for the microcontroller is already written. Now to try on the machine.

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: Impact engraving plugin
« Reply #197 on: June 30, 2012, 08:40:24 AM »
Hi Josaami,

I hope it all goes well.

I would really like to see some pictures of your results, if you get time.

Tweakie.
PEACE
Re: Impact engraving plugin
« Reply #198 on: June 30, 2012, 11:45:21 AM »
Hi Tweakie.
fine. if we can lay out photos.
Re: Impact engraving plugin
« Reply #199 on: July 04, 2012, 05:21:04 PM »
Hi Tweakie!
engraving was good!
shades of gray have not yet done. bitmap picture turned out.
photos very bad quality.