ok now it working i put in pre-amble to code output
G94 an it change the mode on mach3 this is ok
one more think
if i load dxf file and keep layer info. it work ok but i have to enter all the info for layer control
like feed plunger hight ext. take time to enter
if i load dxf and ignore layer inf. the layer control all the info are there if i put outside off
in the inside if i have dot it show the dot and if i generate the gcode all the dot it say Radius to end of arc differ from radius to start on line number #17
N1 (File cut22 )
N2 (File Posted in Mill Mode)
N3 (Wednesday, June 28, 2006)
N4 G90G80G40G94 G90.1
N5 G0 Z10.0000
N6 X37.0742 Y19.0897
N7 M3
N8 Z9.5000
N9 G1 Z0.0000 F300.00
N10 G0G98 Z10.0000
N11 G81 X37.0742 Y19.0897 Z0.0000 R10.0000 F500.00
N12 G0 X197.8373 Y25.6922
N13 Z9.5000
N14 G1 Z0.0000 F300.00
N15 G80
N16 X189.7125 F500.00
N17 Y74.2922
N18 G3 X170.6625 Y93.3422 I170.6625 J74.2922
N19 G1 X67.4625
N20 G3 X48.4125 Y74.2922 I67.4625 J74.2922
N21 G1 Y25.6922
N22 X40.2878
N23 G0 Z10.0000
N24 X203.8787 Y21.1578
N25 Z9.5000
N26 G1 Z0.0000 F300.00
N27 G98 Z10.0000
N28 G81 X203.8787 Y21.1578 Z0.0000 R10.0000 F500.00
N29 G0 X221.0625 Y0.0000
N30 Z9.5000
N31 G1 Z0.0000 F300.00
N32 G80
N33 Y13.6922 F500.00
N34 X238.1250
N35 Y110.1672
N36 G3 X211.1375 Y137.1547 I211.1375 J110.1672
N37 G1 X26.9875 Y137.1547
N38 G3 X0.0000 Y110.1672 I26.9875 J110.1672
N39 G1 Y13.6922
N40 X17.0625 Y13.6922
N41 X17.0625 Y0.0000
N42 G0 Z10.0000
N43 M5 M9
N44 X0.0 Y0.0
N45 G40G80M30
thank you