Hi Art & Brian
Working with Ver.2.0.005 LC
Layers as drawn is back & Working, Thanks
Optomiize drawing, Doesn't remove Redundant lines, As it did in previous version.
Remove Redundants on Load, Has never Removed them for me and still doesn't.
I see Splines are loading now, Thay cut a little funny, LC imports the shape to create them also.
The Move Origin with Mouse is Working Wonderfully, I have had it mess-up with Art's error Msg.'s a couple times, But not at first move of Origin as before, Ill go back and note them and post Soon !!.
Lathe: I must be Missing something hear (Everybody Nodding there Head's, L-O-L U-Hu..a...), OK!, Enough,!!.
Seem's to post the "Roughing" portion of code a little long on both end's
Orientation for start of G-code & return to start point seem's unclear.
Should be at end (Right End at stock OD, Rad. X & Z 0)
Maybe there should be a Start at x,z & Return to X,Z in LC Lathe or Post option's, To allow for clearer setup ?
Maybe If reset Origin to min x, Z then Move Origin to set start point & move it away from profile to stock Dir, Rad., then generate Inc moves to fill/cut into final pass value would/could allow starting at left,Right or Center and use X0, Z0 Start point.
This would allow for Joging/Cutter Calibration and reset to 0,0 for start.
Thanks & Just some Thought's Hear, Chip