Hi Hood
Thank you for quick responce.
I have tryed a lot of parametersetting according to the manual.Torque,velocity,position mode. Nothing runs.
All i/o are connected to a db44 pin connector and to that I have wired
24v +to pin 1 and 24v- to pin 2
for analog input pin 43-44 +/- 10v (differential)
Have also tryed pin 39 and 41 ,without result.
The step/dir. is not an issue for for CSmio-a
I dont have a controller to try the function step/dir.
It is just a bench Work for one motor/driver, so i haven´t
wired alarm and the other things except encodersignal.
That Works fine .I can turn the motorshaft and se the axis move in Mach3.
Right now I have disconnected CSMIO , just to try to get the motor run.
Thanks for helping me Hood.
I have seen a lot of Your videos . I can se that you are a clever guy.
Hope you will give the answer.
Best regards Johnny
http://www.purelogic.ru/files/downloads/doc/Leadshine/servodriver/el5-d1000/EL5_user_manual_Purelogic.pdf