HI RICH thank you, got the LC Manual now. Im reading it slowly page by page. Can you tell me why when I imporrt a dxf drawing to LC let say a square, its only one chain but i has 4 entities (0,1,2,3), so my problem its. when I click them in order one at the time (0,1,2,3) I spect them to go in order around the square but insted they go from left side then to the rigth, then up then bottom. I can see few rapid lines.
What Im doing wrong? what do I have to change to make it go in order around the square?.
thank you
Jaime