Hello Guest it is March 28, 2024, 04:06:48 PM

Author Topic: No response from limit switches  (Read 15942 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: No response from limit switches
« Reply #10 on: April 22, 2013, 02:26:20 PM »
Ok then that will be your problem if they are Normally Closed, you need Normally Closed in series.
Hood
Re: No response from limit switches
« Reply #11 on: April 22, 2013, 02:28:25 PM »
Ok, I will change them over and let you know what happens. Thanks again.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: No response from limit switches
« Reply #12 on: April 22, 2013, 02:30:16 PM »
to test if you press both you should get a change in LED state on diagnostics page.
Hood
Re: No response from limit switches
« Reply #13 on: April 23, 2013, 01:45:45 PM »
Ok, I am getting the change in led state, but no response from the motors?

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: No response from limit switches
« Reply #14 on: April 23, 2013, 01:48:21 PM »
So if you dont press the switches are the LEDs on diagnostics page lit for M1++ etc?
If they are you have the active state wrong.

Hood
Re: No response from limit switches
« Reply #15 on: April 23, 2013, 01:50:42 PM »
no they only light when the switch is depressed.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: No response from limit switches
« Reply #16 on: April 23, 2013, 01:54:25 PM »
Ok so the reset does not flash when you press them?
Hood
Re: No response from limit switches
« Reply #17 on: April 23, 2013, 01:55:26 PM »
no, they have no effect on anything.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: No response from limit switches
« Reply #18 on: April 23, 2013, 01:57:07 PM »
Ok attach your latest xml and also what version of Mach do you have loaded?
Hood
Re: No response from limit switches
« Reply #19 on: April 23, 2013, 01:59:45 PM »
the xml is the one already attached, and I am running the latest version of mach 3.