Hello & Help
 We got a new M4a mill & installed the Mach3 software , never got the x4xml file , found one on the net & loaded it . after trying a few things i can get z to home out but x & y just run past the limits . the home switches show they're working .  Any help would be appreciated !!
            Thanks , Steve

When you tested the switches did both the limit AND the home led light up or just the limit led?

(;-) TP

I've tried it both ways with just the home witches & then with x++ & y++ also activated , no luck

(;-) You did not answer the question. 

(;-) TP

the home#3 lights up

When you trip the home for X then Y then Z do they light up the same LED? or different leds ?

(;-) TP

3 different Z=home 1  X=home 2  Y=home3

I don't see any logical reason for it NOT to work IF the Homes are showing trips. Perhaps post your XML file and have HOOD take a look see.

(;-) TP

thanks,  i'll post it tomorrow
            steve

MIght want to look at home assignment again  I know them as Home1=X  Home2=Y   Home3 =Z

Just a thought, (;-) TP