Hello Guest it is May 10, 2025, 01:19:57 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Saving Fixture Offsets  (Read 5188 times)

0 Members and 1 Guest are viewing this topic.

Offline babinda01

*
  • 32 32
Saving Fixture Offsets
« on: June 17, 2010, 11:56:06 PM »
Hi
Is there a way to save the fixture offsets from vb.  I have tried DoOEMButton(122), but this still requires you to press the save button.  I am setting my offsets with setVar(5241), but then I am wanting to save the changes.

Andrew
Logged

Offline BR549

*
  • 6,965 6,965
Re: Saving Fixture Offsets
« Reply #1 on: June 18, 2010, 01:34:59 AM »
Have you tried using persistant offsets in the config general section? that should auto save the offsets.

Other than that I don't know of a way.
Logged

Offline babinda01

*
  • 32 32
Re: Saving Fixture Offsets
« Reply #2 on: June 18, 2010, 01:57:29 AM »
Hi
Thanks for your reply.  I have persist offsets ticked, but still no joy. I have tried .DoMenu(1,14) but that doesn't work either.

Regards
Andrew
Logged

Offline BR549

*
  • 6,965 6,965
Re: Saving Fixture Offsets
« Reply #3 on: June 20, 2010, 12:52:50 PM »
Andrew have you tried using SENDKEYS to allow VB to push the buttons on the screen?
Logged

Offline Tarak

*
  • 229 229
Re: Saving Fixture Offsets
« Reply #4 on: June 21, 2012, 06:48:37 PM »
Hi, did you guys have any luck with the VB code?
I've tried to set a button to save the offsets, so if there is power out, I can start back up and it's got the correct coords after I reference the machine.
Logged
Pages: 1   Go Up
« previous next »