Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: babinda01 on June 17, 2010, 11:56:06 PM
-
Hi
Is there a way to save the fixture offsets from vb. I have tried DoOEMButton(122), but this still requires you to press the save button. I am setting my offsets with setVar(5241), but then I am wanting to save the changes.
Andrew
-
Have you tried using persistant offsets in the config general section? that should auto save the offsets.
Other than that I don't know of a way.
-
Hi
Thanks for your reply. I have persist offsets ticked, but still no joy. I have tried .DoMenu(1,14) but that doesn't work either.
Regards
Andrew
-
Andrew have you tried using SENDKEYS to allow VB to push the buttons on the screen?
-
Hi, did you guys have any luck with the VB code?
I've tried to set a button to save the offsets, so if there is power out, I can start back up and it's got the correct coords after I reference the machine.