Ok we kind wondered off...
I want to use one button to home 3 axis. XY and Z. I have the ports and pins set correctly, including the A it is not activated in mach.
The problem is if you referance 1 axis at a time you can get through all 3, but if you ref all home it will start the sequance and then after hitting the Z home, it refuses to go any further...
All axis are still active with galil, there is no galil fault.
If I hit the ESC key it will not continue because the sequance was stopped.. If you hit ref all home again it will back off the switch and stop.. Then I haave to hit ESC again... It will do the samething with X then Y...
You can ref all home if you do it 1 axis at a time, in the setting screen.... No problems at all that way...
It is not really a problem if I can not get the ONE button approach to work, UNLESS the problem can be somewhere else??? Like refrancing during a tool change(manual), during a long program just to make sure 100% each segment is correct... It is a really pain to have a 12, 18, or even a 24 hour program loose position...