It looks like Mach gives you a choice of two addresses. One begins with 378, the other with 278. The number of the one in this computer might be 828 if I follow what you're saying. I'm going to shut this thing down (along with my email) long enough to check the properties on my old computer.

Roger. I'll check.

Did you use the xml from your last computer?
Hood

Is this it?

Nope 03F8 is a com port, its a printer port you want to look at.
Hood

Did you use the xml from your last computer?
Hood

I don't know what an xml is. I'm assuming you're asking if the info I'm putting up is from the computer that isn't working with Mach. The answer to that is yes.

Nope 03F8 is a com port, its a printer port you want to look at.
Hood

Will do. Keep my name in mindd.

This should be it.

lol, your in good company then, talk about blind leading the blind

Ok your old computer had Mach installed and working? If so and you can still access it look in the Mach3 folder on the C drive of it. You will see a file called Mach3Mill.xml (thats presuming its Mill you were using). If you copy that then paste it into your new computers Mach3 folder all your old settings will be as before. The only thing that could be different is the Port address.

Hood

Yes thats oit, standard on board printer port address, 0378.
Hood