Hello Guest it is December 08, 2021, 08:13:14 PM

Author Topic: No reverse on homing y  (Read 2652 times)

0 Members and 1 Guest are viewing this topic.

No reverse on homing y
« on: February 19, 2008, 12:53:38 PM »
My machine has taken to erratic behaviour when homing all axis. z and x ok but sometimes y will back off  the limit switch as it should and other times just stops when it hits the switch and gives  an error message. Where is the routine that controls thiis? Can it be corrected iby an edit  or is it a corruption further back? Thanks, Ralph

Offline Hood

*
  •  25,838 25,838
  • Carnoustie, Scotland
    • View Profile
Re: No reverse on homing y
« Reply #1 on: February 19, 2008, 01:40:07 PM »
what is the error message?
Hood

vmax549

*
Re: No reverse on homing y
« Reply #2 on: February 19, 2008, 01:49:34 PM »
YOu may have a sloppy switch, try increasing the debounce setting.

(;-) TP
Re: No reverse on homing y
« Reply #3 on: February 19, 2008, 02:39:53 PM »
Well, I replaced the switch and it works correctly. If the old one did not produce a sharp, complete break, that could be responsible. Ralph