Hello
Guest
it is
April 21, 2025, 06:59:12 AM
Guest
Login
Register
Menu
Home
Help
Search
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
No reverse on homing y
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: No reverse on homing y (Read 7296 times)
0 Members and 1 Guest are viewing this topic.
ktmodelshop
9
No reverse on homing y
«
on:
February 19, 2008, 12:53:38 PM »
My machine has taken to erratic behaviour when homing all axis. z and x ok but sometimes y will back off the limit switch as it should and other times just stops when it hits the switch and gives an error message. Where is the routine that controls thiis? Can it be corrected iby an edit or is it a corruption further back? Thanks, Ralph
Logged
Hood
25,835
Carnoustie, Scotland
Re: No reverse on homing y
«
Reply #1 on:
February 19, 2008, 01:40:07 PM »
what is the error message?
Hood
Logged
vmax549
Re: No reverse on homing y
«
Reply #2 on:
February 19, 2008, 01:49:34 PM »
YOu may have a sloppy switch, try increasing the debounce setting.
(;-) TP
Logged
ktmodelshop
9
Re: No reverse on homing y
«
Reply #3 on:
February 19, 2008, 02:39:53 PM »
Well, I replaced the switch and it works correctly. If the old one did not produce a sharp, complete break, that could be responsible. Ralph
Logged
Print
Pages:
1
Go Up
« previous
next »