Hello Guest it is November 28, 2021, 07:47:23 AM

Author Topic: Mach3 macro homing  (Read 596 times)

0 Members and 1 Guest are viewing this topic.

Re: Mach3 macro homing
« Reply #20 on: July 02, 2021, 01:20:25 PM »
Hi TPS,

thanks for your reply, I will link this to Andrew at warp9.

Regards Morten

Offline TPS

*
  •  2,210 2,210
    • View Profile
Re: Mach3 macro homing
« Reply #21 on: July 02, 2021, 01:28:14 PM »
attached a macro i use on one of my machines.

and this is a typical Header for my g-code

Code: [Select]
N0001 %1 (Teutoburger GC01 +C01 Tür links)
N0002 G61                                 (Genauhalt)
N0003 G90                       (Absolute Maßangaben)
N0004 G90.1                             (I/J absolut)
N0005 M5                                (Spindel aus)
N0006 G17                             (X-Y Fräßebene)
N0007 G21                               (alles in mm)
N0008 G40                       (Radiuskorrektur aus)
N0009 G49                       (Längenkorrektur aus)
N0010 G50                         (Skallierungen aus)
N0011 G54                  (Werkstückkoordinaten ein)
N0012 G43 H0             (Werkzeughöhenkorrektur aus)
N0013 M1004               (alle Achsen referenzieren)

i run this macro in all my programs
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Mach3 macro homing
« Reply #22 on: July 02, 2021, 01:31:32 PM »
Thanks TPS,

I have written to Andrew and asked him to check this topic and your post, I will update this topic when I know more, thanks again!

Regards Morten