Buying quality is preferred, but Yep, true, in hobby world dreams meet the purse strings.
I looked at the Limit Switches, they stop current flow when activated .... that's NC, isn't it. If yes, it's a little counter intuitive as you can not walk through a closed door
.
The cables attached to the motors and switches are "Black Box Corp 6/C Type CMR (UL) c(UL) 75C E116394; is that a suitably shielded cable or best totally replaced?
In relation to the spindle control; I would prefer to initially keep my present set up, which is mains power and manual speed control by adjusting the potentiometer built into the spindle motor casing. I would certainly like to upgrade the spindle control to a computerised one as a future project.
A request for specs to determine quality, for all the required items yet to be purchased has been sent to a few suppliers. Awaiting a reply.
I saw the # X Axis LS and yes, did not understand .... will speak up next time.
I'll give you the specs of items (to be) purchased as they arrive.
What Mains Switch are you talking about, MN300, the wall switch for the 240V power supply?