Hello Guest it is March 28, 2024, 01:01:12 PM

Author Topic: Radius to end of arc differs from start  (Read 1756 times)

0 Members and 1 Guest are viewing this topic.

Re: Radius to end of arc differs from start
« Reply #10 on: November 19, 2020, 01:11:12 PM »
Does anyone know how I can fix the problem  in Mach 3  ?? 

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Radius to end of arc differs from start
« Reply #11 on: November 19, 2020, 02:14:04 PM »
pls post your "Profile".xml file
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline Graham Waterworth

*
  • *
  •  2,668 2,668
  • Yorkshire Dales, England
    • View Profile
Re: Radius to end of arc differs from start
« Reply #12 on: November 20, 2020, 03:21:04 PM »
The code I posted was in Diameter mode so if you change Mach to diameter mode all should look good.

Are you using Radius mode for any special reason, most lathes are programmed Diameter.
Without engineers the world stops