Hello Guest it is October 22, 2020, 11:09:35 PM

Author Topic: Homing and Limit Configuration  (Read 90 times)

0 Members and 1 Guest are viewing this topic.

Homing and Limit Configuration
« on: October 13, 2020, 05:26:04 AM »
I have a Sherline 5410 (metric) milling machine running through a cheap Chinese breakout board by Bitsensor.com model BSMCEO4U-PP.  I have all the axes and pin setup correcting where I can jog back and forth through Mach3.  However; my problem is setting up my homing/limit configuration.  I have looked at many online tutorials and some of them can be a little confusing to a person unifiliar to Mach3.  Dose anyone know the proper setup for homing/limit configuration for a Sherline Mill or should I say does anyone know of a good tutorial step-by-step guide for a newbie to Mach3?

Offline TPS

*
  •  1,721 1,721
    • View Profile
anything is possible, just try it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Homing and Limit Configuration
« Reply #2 on: October 13, 2020, 08:16:40 AM »
  :)  Thank you for the help.