Yes your right,
I took a break, now I am getting the correct voltage from the SSR and the on board relays.
The Arduino relay's are working correct with both SSR onboard and on board relays... so I have 4 outputs working...
Yes that's picture is close to the board I have, mine has 2 screw terms 1 for vcc input voltage also a barrel connector for input voltage
and a 2 screw term I assume for output voltage...
I thing I can't seem to do is get any of the pins I try to use on the pokeys to work other than the relays, I tried the LCD connector and a couple others but when I set the pins I get no change to voltage.
I did get the LCD to change, but the problem was when I connected it to the relay SSR or Arduino it would read unconnected 4v connected 0
almost like it couldn't hold voltage when the relay was connected..
Gary