Ok I got the C25S plugged into my smoothstepper. Smoothstepper is configured with my network card and seems to be recognized in mach4 but I need to know what to set in the smoothstepper and Mach configuration in mach4. As is my motors will not respond to jog but they are locked so I know they are getting signals. I looked at one of the videos from Daz but the smoothstepper he used in the video was an early version so all the configuration screens were different. I have the latest versions of everything. Below is my system.
I have (5) Gecko 251S drivers for XYZAB axis and they are connected according to Gecko instructions.
Smoothstepper board NOTE: I do not know lf the jumpers are set right so I left them as received.
C25S BOB with port (1) configured as pin 2/3 X pin 4/5 Y pin 6/7 Z pin 8/9 A pin 1/17 B
NEMA 17 motors
I think I covered everything hopefully someone can help me with the correct settings.