Yes, that would make sense, also the following error fix too
Im still a bit grey though on function, you set the setter all the way down, does this position matter though - where is "all the way down" in reference to an R8 socket?
Yes i can see calling the Haimer 100 (etc) would be good, storing the height - but what height? Where is zero?
Would it be just the top edge of my fake R8 socket - touch that as home and zero the DRO then insert T100 (Haimer) set to zero on the dial and store the height?
Then insert other tools, read the height and store them?
If yes then its a little clearer - I am currently measuring offsets you are measuring heights - similar but not the same.