Hi, Wes

I'm using LC version as of todays date, That's the only way i've figured out how to now what Ver.it is, When did you up-date LC last ?

The bottom profile looks good, But top is off in your post, Better than Mine.

I drew the A-foil in Turbo-cad 8, Hand drawn with spline feature, It doesn't relate to any foil data sheet.

Hear's a picture of it in Mach3, ready to cut 20 blade's.

Thanks, Chip

I just updated my lcam and mach3 with the latest betas on the download page  Lcam 2.02 created May 21, Mach3 2.0.073 created May 25.
I was showing these version before but i did a full reinstall just in case.  Fresh downloads and installs.
Same result as i posted.  I've been trying to make mine look like yours but no luck yet.

Art-Brian did ya know that when you install the Mach 3 beta it installs the old version of Lcam?

Hi, Wes

I deleted my LC.xml and wound up with a offset like yours still has a problem on top line.

Thanks for the update on your versions, Helped me figure out the xml was the major problem.

Thanks, Chip

Hi, Brian

Deleted my Xml and try-ed it again, It's much better except the nose.

Shown with .01 offset's.

In offsets, It looks like LC is using the portion of Dxf that generates the Spline Profile shape, as LC did in earlier normal file in-port.

Thanks, Chip

The DXF for this is on page 1 & below.

Hi, Brian

Hears a copy of the DXF for above Picture, Forgot to tell you it was on page 1.

Thanks, Chip

Hi, Art & Brian

Having problems with Pocket & Offset's.

It looks like LC is using the portion of Dxf that generates the Spline Profile shape, as LC did in earlier normal file in-port.

Attached below is DXF for box around air-foil, Trying to cut box area and leave Air-Foil.

Needing Some Help Hear.

Thanks, Chip

You will need to use the zigzag to get it to work

thanks
Brian

Hi, Brian

With  Zigzag it dose the same, Thy also don't finish the Offset's or Pocket's.

In offsets & Pocket's, It looks like LC is Using the portion of Dxf that generates the Spline Profile shape, Not the Spline, As LC did in earlier normal file in-port's.

Look up a few Post's above,

How about posting this Working/Screen Shot, Show Me The Error's I've Made, Many hours spent for such a blow off answer, Just trying to post bug's I Find.

May Be Me, Been there Before, May Be You, Seen That Too. and I now it's a Bata-Bata Version

Thanks, Chip

Chip just playing with the airfoil DXF
Wes

Hi, Wes

Thanks, If you'll tighten the Offset up close you will see the errors on the off-setting the airfoil, It's not using the Spline line for off set's.

It looks like LC is Using the portion of Dxf that generates the Spline Profile shape for the offset's, As LC did in earlier normal file in-port's.

Just blowing off some Steam Hear.

Thanks, Chip