I am back to as far as I have been.............
I have.............in Darwin
Deleted Sim
Deleted M3,4 and 5 macros
I have port 1set on 0x0378
motors 0,1,2 enabled
Pins for step 16,4,6 Dir 17,5,7 all on port one, negate checked on all.
input signal 1 set on pin 10 negated for emergency
no other inputs enabled, no outputs enabled.
I get green lights and velocity movement on when using job ball.
No physical motor movement.
M4 motors set at 10000 counts per unit,80 units velocity,8 units acceleration inch units
motors 0,1,2 enabled as X,Y,Z
homing as 2,2,1 order
input 1 as emerrgency enabled, no other inputs or outputs enabled
When viewing diagnostic page and jogging machine status changes from idle to jogging
feed rate goes to 40.8
i/o lights status input 1 green all others dark
outputs enable 0,1,2 all green others dark
When disabled, input 1 stays green, enables go dark
after a time, history file says license file failure and no more dro movement when jogging
If i load license, and restart as instructed, machine crashes.
BAR