Hello Guest it is July 07, 2020, 12:17:04 AM

Author Topic: How do I setup so mach3 starts with certain codes.  (Read 1386 times)

0 Members and 1 Guest are viewing this topic.

How do I setup so mach3 starts with certain codes.
« on: October 30, 2014, 10:04:28 PM »
How to I set up mach3 so at start up it automaticly goes to say "G20 G55 M6T1" and make sure turn tool offset off etc?

Offline RICH

*
  • *
  •  7,410 7,410
    • View Profile
Re: How do I setup so mach3 starts with certain codes.
« Reply #1 on: November 01, 2014, 08:08:59 AM »
You can use an Initialization Macro.

An example for my lathe can be found in Threading on the Lathe - Mach3Turn writeup, Apendix "C" page 57.


RICH