Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jmorris on October 30, 2014, 10:04:28 PM

Title: How do I setup so mach3 starts with certain codes.
Post by: Jmorris on October 30, 2014, 10:04:28 PM

How to I set up mach3 so at start up it automaticly goes to say "G20 G55 M6T1" and make sure turn tool offset off etc?

Title: Re: How do I setup so mach3 starts with certain codes.
Post by: RICH on November 01, 2014, 08:08:59 AM

You can use an Initialization Macro.

An example for my lathe can be found in Threading on the Lathe - Mach3Turn writeup, Apendix "C" page 57.


RICH