Hello Guest it is August 26, 2019, 01:33:56 AM

Author Topic: Motor tuning  (Read 1181 times)

0 Members and 1 Guest are viewing this topic.

Motor tuning
« on: July 08, 2014, 06:39:45 PM »
Simple question.
When driving through an external motion controller card, Galil to be specific, which has its own motor tuning, does the Mach 3 motor tuning still apply?  If not, is there a default setting which should be set?  In general I find the documents poor when it comes to describing the differences between what is required for driving through the printer port and driving an external motion card.

Offline Hood

*
  •  25,849 25,849
  • Carnoustie, Scotland
    • View Profile
Re: Motor tuning
« Reply #1 on: July 09, 2014, 02:32:21 PM »
There should be some form of documentation for the Galil and Mach. Probably best asking on the Galil section of this forum.
Hood