Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: tonyfoale on July 08, 2014, 06:39:45 PM
-
Simple question.
When driving through an external motion controller card, Galil to be specific, which has its own motor tuning, does the Mach 3 motor tuning still apply? If not, is there a default setting which should be set? In general I find the documents poor when it comes to describing the differences between what is required for driving through the printer port and driving an external motion card.
-
There should be some form of documentation for the Galil and Mach. Probably best asking on the Galil section of this forum.
Hood