Recently I have swapped the ESS Smoothsteppper for the CS-Lab CSMIO/IP-S controller
When I startup Mach3 I perform a x-y-z Axis reference this is done perfectly
Then I enable the Software Limits.
Now I cannot move any axis in step mode or with G-code, when I try this I get an error message: see picture below.
The weird thing is: the only way to move the Axis with soft limit ON is if JOG is in continues mode.
Whit Soft Limits disable every thing works fine.
What can occur this problem?
Is this a CS-Lab error message? I have never had this problem or see this message before with the Smootstepper controller.
I have the latest Mach3 .066 installed and the latest CS-LAB v2.100 Plug-in installed.