Warp9 E189010
smoothstepper driver Ver 17efb, 37, 2.08.36.
the z motor does not lock - the new motor does not lock.
I reversed the pins no luck
I swapped the z x cables on the controller z did not jog but, x would jog on z or x. [controller ok]
I put x on z of the controller and it jogs. [cable ok, controller ok.]
Mach3 knows and shows jogging. SS diag shows the movement in mach3.
I'm looking at the SS driver or board ? no signal is getting to z
Whats left
??