Hello Guest it is May 23, 2019, 11:47:30 PM

Author Topic: No signal to Z  (Read 3781 times)

0 Members and 1 Guest are viewing this topic.

Offline Chaoticone

*
  • *
  •  5,496 5,496
  • Precision Chaos
    • View Profile
Re: No signal to Z
« Reply #10 on: May 26, 2013, 02:26:35 PM »
The only things between the control box and the output shaft on the motor is the motor, wires and any connectors.

Brett
« Last Edit: May 26, 2013, 02:30:18 PM by Chaoticone »
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!

Offline Chaoticone

*
  • *
  •  5,496 5,496
  • Precision Chaos
    • View Profile
Re: No signal to Z
« Reply #11 on: May 26, 2013, 02:39:26 PM »
I have sent you a PM.

Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!

Offline Chaoticone

*
  • *
  •  5,496 5,496
  • Precision Chaos
    • View Profile
Re: No signal to Z
« Reply #12 on: May 26, 2013, 02:42:20 PM »
No, never mind the PM.

Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!