strange behaviour with the OD fillet 2 from the lathe wizards?

Post a screenshot of the settings you have entered please.
Hood

What lathe mode are you using..... diameter or radius ?
Some of the wizards don't work in both modes if memory is correct and don't know which ones they are.

RICH

I am using diameter

I cant get it to work correctly either,I have to reverse the arc direction for it to look ok with my xml. Looks like its just another thing that doesnt work correctly in Turn
Hood

I altered the wizard to put out G3's rather than G2's and it works ok form me now.
If you can attach your xml I will have a look and see if I can find the problem with your setup.
Hood

here it is

Zeeschium,
I don't know what you did to accomplish what you posted in reply #0.
( could be where you defined X axis position before you ran the wizard )
Using your xml and also your inputs I get what you get in reply #3.
Compared the two different gcodes and looks like you were using different inputs or even config for reply #0.

RICH

Using your xml I too get it working fine.
Hood

I get the strange behaviour when I run f the file.
Hood: did you run the file?