I loaded my gcode, write 2500 to "line" section, hit enter and gcode windows went that line. When I hit "run from here" gdoce goes to line 0, top of gcode.
I tried different combinations of "load gcode", "set next line", "run from here", "rewind" buttons, and different line numbers for starting point, but no luck. I dont know how this "run from here" button supposed to work.
that mach3 application is very good software but its some portions definitely need to be revised. There should be a trick to work with "run from here". I searched forums, google it, but could not find solution.
do you have any idea how to use it ? can you give me step by step instructions like:
load g-code
enter line number (while reset button is active, ie: motors are not running)
hit "set next line"
While reset button is inactive (while step motors are running)
hit "run from here"
of course this directions not working, at least for me... When I hit "run from here" gcode ayways starts from beginning...
this is the beginning of the code... maybe you could say "this situation is related with the codes at the top of gcode"
T1M6
G17
G0Z12.860
G0X0.000Y0.000S15000M3
G0X14.000Y8.600Z5.000
G1Z-0.020F1200.0
G3X13.000Y7.600I-0.000J-1.000F600.0
.... and goes on...