Hi,
Thanks for the replies!
-Enhanced pulsing is not on
-Constant Velocity is on
-Can't find CV mode, I am using Mach2
Here are a few more questions I have that might be an issue:
-In BIOS my com port 1 is set to EPP, is that right? There is two other settings ECP and Bi-directional.
-In Mach 2 com port 1 baud rate is at 9600, should that be set higher? my wire is quite short.
-When I was reading the manual for the stepper driver they were talking about a 5 amp 250 vac fast acting fuse, my machine keeps blowing them, the fuse is located at the power supply, I am using a 6.3 amp fuse and it hasn't blown yet. The guys from k2 said it wasn't a problem. What do you think?
Thanks Brian, I will keep in touch with you, The problem is intermitten, Yesterday I ran two programs one to ruff and semi-ruff then on the third program to semi finish it screwed up and lost location and I ran the program about 4 or 5 times and it kept screwing up. Then it worked on the 6th time, then my finishing program ran fine but I wasn't running it at the feed that I wanted to, because of fear that it would screw up. I found if I run it fast it screws up more. This is what it does on a constant basis no specific axis they all screw up at different times. The only thing that I noticed is that all axis freeze up and once it finishes getting to the point it starts back up again out of location. It depends on how much damage being out of location does decides if my part is scrap.
Thanks guys,
Greg