Yes, I have installed them as instructed.
THC Mach3 Files
--------------------------------------------------------------------------------
Downloads
--------------------------------------------------------------------------------
Download the THC300SM3 Zip File here (contains all of the files listed below in a single zip file) updated 6-1-08
THC300
Copy the Bitmap folder into the MACH3/Bitmap/ folder
Copy the THC300SM3.XML and the THC300S.SET files
into the Mach3 folder
Make sure your license file is in the Mach3 folder as well.
THC300 set updated 6-1-08
THC300 XML file Pin settings for both ports
THC300 Screen Snapshots
So now after reinstalled mach several times I have all the motors set right and the table itself is operating fine. I just cannot get te THC to work. I know that the 2nd port is working because the signal for the touch off is working. I just have to torch when I press the torch on/off button in mach3