Hi to all
I need to get the wiring connections sorted out first. As of yet the changer is not connected to any thing
I need to get the relay for the 12/24volt change over controlled by mack ( how do I configure this, ports / pins, and configuration / setup in mack3)
If the wires coming out of the changer greyscale sensors are or were made to be +5volts active and 0 volt inactive (not fitted to bob) would this be a basic digital signal? Can mach3 understand it
How do I set up ports and pins and configuration to do this.
Then as I understand it I will need to have a macro to make it all work properly. But at this stage I think this is the least of my problems.
Many thanks for all your help so far with this I have read all replies but am still lost with it all.I starting to wonder if its worth all the trouble and might be better to use it as a manual changer with a single panel mounted push switch, but this sort of defeats the object and purpose of having it.
Bert