Hello
Guest
it is
March 28, 2024, 08:55:25 PM
Guest
Login
Register
Menu
Home
Help
Search
Calendar
Members
Members
View the memberlist
Search For Members
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
Having an issue with arcs O ring pocket code.
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: Having an issue with arcs O ring pocket code. (Read 3445 times)
0 Members and 1 Guest are viewing this topic.
fixittt
289
Having an issue with arcs O ring pocket code.
«
on:
December 10, 2010, 04:23:33 PM »
We are having an issue with this g code. It works on a HAAS machine fine.
Problem is, its suppost to cut an o ring grove .5 inchs in diameter. But its giving us a 1 inch or better pocket.
Any ideas? Problems that you may see?
Logged
Hood
25,835
Carnoustie, Scotland
Re: Having an issue with arcs O ring pocket code.
«
Reply #1 on:
December 10, 2010, 04:40:31 PM »
Works fine here, think you may have the IJ mode set wrong, change it from General Config page from Abs to Inc.
Hood
Logged
fixittt
289
Re: Having an issue with arcs O ring pocket code.
«
Reply #2 on:
December 10, 2010, 05:01:52 PM »
That did it! Thanks! I dont deal much with arc fitted toolpath with what I do........ THANKS BUNCHES!
Logged
Hood
25,835
Carnoustie, Scotland
Re: Having an issue with arcs O ring pocket code.
«
Reply #3 on:
December 10, 2010, 05:19:37 PM »
Really your code should define the mode, if you had a G91.1 at the beginning of the code it would have run fine even though Mach was set to Abs (G90.1) the code would have overridden Machs default.
Hood
Logged
fixittt
289
Re: Having an issue with arcs O ring pocket code.
«
Reply #4 on:
December 10, 2010, 05:57:27 PM »
I will pass that info along to the end user, Thank you! I dont know enough about arc toolpath yet.
Logged
Hood
25,835
Carnoustie, Scotland
Re: Having an issue with arcs O ring pocket code.
«
Reply #5 on:
December 10, 2010, 05:59:37 PM »
You probably know more than me
Hood
Logged
Print
Pages:
1
Go Up
« previous
next »