Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: fixittt on December 10, 2010, 04:23:33 PM
-
We are having an issue with this g code. It works on a HAAS machine fine.
Problem is, its suppost to cut an o ring grove .5 inchs in diameter. But its giving us a 1 inch or better pocket.
Any ideas? Problems that you may see?
-
Works fine here, think you may have the IJ mode set wrong, change it from General Config page from Abs to Inc.
Hood
-
That did it! Thanks! I dont deal much with arc fitted toolpath with what I do........ THANKS BUNCHES!
-
Really your code should define the mode, if you had a G91.1 at the beginning of the code it would have run fine even though Mach was set to Abs (G90.1) the code would have overridden Machs default.
Hood
-
I will pass that info along to the end user, Thank you! I dont know enough about arc toolpath yet.
-
You probably know more than me :)
Hood