SUCCESSS!!!!!!! I can start and stop the spindle! I ordered a laser tachometer off Amazon.com, so i have to wait for it to show up. Then i can actually tell what RPMS it is spinning @. wow! That converter did the trick, super easy!!
For some reason my speed is limited to 8000rpm inside mach. I think i have to configure it. Also, i see "spindle CW F5" that starts and stops my spindle im assuming in the clockwise direction. What about counter clock wise? Is there a better spindle controller screen i can select? I'm using the stock mach 3 screen set. What does everyone prefer?