Hello Guest it is May 02, 2025, 07:51:35 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Lathe feed rate overide not working?  (Read 6964 times)

0 Members and 1 Guest are viewing this topic.

Offline softselect

*
  • 62 62
Lathe feed rate overide not working?
« on: January 07, 2010, 03:33:34 PM »
Hi everyone,
I have just revamped my "all in one" lathe screen and i found the feedrate override% values change in the DRO but during a cut it does not affect the feed rate
anyone else have the same problem?
my new all in one screen set can be found here
http://www.machsupport.com/forum/index.php/topic,13544.msg88912.html#msg88912
thanks
Friedrich
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Lathe feed rate overide not working?
« Reply #1 on: January 07, 2010, 06:52:19 PM »
I think it works fine for me but I am not using the latest version of Mach, I will try and remember to make sure tomorrow.
Hood
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Lathe feed rate overide not working?
« Reply #2 on: January 08, 2010, 06:06:39 AM »
Just tested here and FRO works fine with both G95 and G94 but I am using an older version on the lathe (021) and also the SmoothStepper. Maybe RC or Rich will be able to test for you with the parallel Port.
Hood
Logged

Offline softselect

*
  • 62 62
Re: Lathe feed rate overide not working?
« Reply #3 on: January 08, 2010, 10:12:32 AM »
Thanks Hood at least i know the screenset is ok
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Lathe feed rate overide not working?
« Reply #4 on: January 08, 2010, 10:21:44 AM »
ah, didnt try with your screenset, sorry, will try later if I get a chance, kind of busy with the lathe at the moment
Logged

Offline Hood

*
  • 25,835 25,835
  • Carnoustie, Scotland
Re: Lathe feed rate overide not working?
« Reply #5 on: January 08, 2010, 10:49:32 AM »
ok tried your screenset and its working :)

Hood
Logged
Pages: 1   Go Up
« previous next »